Epoxy Flooring in Clovis, CA

Garage Floor Coating for Clovis Homes

Most Clovis garages we see fall into one of two categories. Newer builds in Loma Vista, Harlan Ranch, and the developments feeding Clovis North and Clovis West have clean, relatively young slabs that take a coating beautifully with minimal repair work. Older homes closer to Old Town and along the Shaw and Herndon corridors usually need some crack chasing and patching first, and occasionally a moisture test if the slab was poured without a vapor barrier.

Either way the process is the same on our end. We diamond grind the entire surface to open the concrete pores, repair cracks and spalled areas with a structural patching compound, then apply a primer, a pigmented base coat, and a clear topcoat. If you want a flake finish, the vinyl chips get broadcast into the wet base coat and locked under the clear. Nothing we install is acid etched, because acid etching is the single most common reason a Clovis garage floor peels within two years.

A standard two-car garage in Clovis is a one-day install. Three-car and RV-depth garages sometimes run into a second morning, mostly because of grinding time rather than coating time. You get light foot traffic back after 24 hours and can park on it after 72.

Why Clovis Concrete Behaves the Way It Does

Summer surface temperatures inside an uninsulated Clovis garage regularly climb past 110 degrees, and that matters more than most homeowners expect. Heat accelerates the cure, which shortens the working window and makes a rushed or under-staffed crew leave roller marks and lap lines. We schedule Clovis installs for early starts in July and August for exactly that reason, and we adjust the hardener ratio to the actual slab temperature rather than the air temperature.

Hot tire pickup is the other local reality. When a car pulls into a hot garage, the tires stay soft and grip the coating as they cool. A thin water-based product bonds weakly and lifts off in patches shaped like tire treads. The 100 percent solids epoxy we use, over ground concrete and under a polyaspartic topcoat, is not vulnerable to this.

Commercial and Shop Floors in Clovis

We are not just a residential outfit. Clovis has a steady base of auto shops, fabrication shops, dental and medical offices, and light industrial tenants along the Clovis Avenue and Sierra corridors, and all of them need a floor that cleans up fast and does not stain. For those spaces we install heavier-build systems with a non-slip aggregate in the topcoat, and we can phase the work over a weekend so you are not closed on a Tuesday.

Restaurants and food service tenants in Clovis have an additional constraint, which is that the floor needs to be seamless and cove up the wall so there is no joint for anything to collect in. We install that detail as a matter of course on food service jobs.